Pool Light Repair in Irving, TX

Pool Light Repair in IRVING, TX

Our IRVING Certified Residential Appliance Installers can quickly and safely complete your pool light repair.  Don’t let a non-licensed technician do your repair– for the safety of your family.

Pool Light Repair Regulations in IRVING, TX

It was 1968 when the National Electrical Code (NEC) finally decided to include swimming pools in their standards and regulations (article 680). If your pool was built prior to 1968, there likely exists some sub-standard electrical design for your underwater lighting and filter pump. You may wish to update this at some point for safety reasons.

If your IRVING Pool Light doesn’t turn on?

Check all breakers, fuses, switches and Ground Fault Circuit Interrupter (GFCI) outlets. Frequently, a GFCI outlet is wired into the UW light circuit. If the GFCI ‘red button’ has popped out, the power will not continue on towards the light.  Be sure all of these switches are in the “ON” position. If you find that a breaker, fuse, or GFCI continues to trip, and the light will not come on, you should call for service at this point to determine where this problem  is originating. If all switches are on, but there is no light, we would remove the fixture from the socket and inspect the bulb for continuity (Of course, we have turned all switches / breakers OFF at this point). Burnt bulbs are replaced with identical voltage bulbs, of either 12 volts or 120 volts. 12 volt bulbs are 300 watts, while 120 volt bulbs are available in either 300 or 500 watts. These are medium based, reflective flood lamps of special design. Do not use your garden variety flood lamp bulb.

Pool lights in IRVING we service and repair

Customers found this page by searching for one of the following search terms:

IRVING, TX pool light service | IRVING, TX pool lights | pool lights in IRVING, TX | hayward pool lights IRVING, TX  | pentair pool lights IRVING, TX | jandy pool lights IRVING, TX | sta-rite pool lights IRVING, TX